Sharp LC-M3710 Computer Monitor User Manual


 
US
44
If execution of the command is taking some time.
W
Carriage return code
(0D
H, 0AH)
A I T
If execution of a command takes some time, WAIT may be returned as the returned value. In this
case, a value will be returned if you wait a while. During this time, new commands will not be
received, even if they are sent.
No ID number is attached to WAIT response.
LOC K
ED
Carriage return code
(0D
H
, 0A
H
)
T
Carriage return code
(0D
H
, 0A
H
)
I M E O U
T
Carriage return code
(0D
H, 0AH)
TIM E O U
T
0 0 1
SPC
Space (20H)
Cases where WAIT is returned
1. When repeater control is used
2. When an IDSL or IDLK command is used
3. When one of the following commands is used: RSET, INP1, INP2, INP3, INPC, INPS, ITGD,
IAVD, IPCD, CLSY, ASNC, WIDE, EMAG, EPOS, PXSL, POWR
PC Operation (Continued)
When control via RS-232C is locked (to prevent use) using the Control lock function (see page 54).
If a timeout occurs while waiting for a command
If a timeout occurs while waiting for a command (when the monitor waiting for the command is
assigned an ID number = 001 in the following example)
If the current parameter is read out using "?" for the parameter (for numerical values etc.)
1Response when no ID number has been set.
<Example> VOLM????
10
2Response when an ID number has been set. (In the example below: ID=001)
<Example> VOLM????
10 001