Filter
Top Products
6
TROUBLESHOOTING
56
CONTENTS INDEX
If a notice page is printed
(part 1)
If you find that a notice page has been printed at the end of a print job, the print data received from the computer has not been
printed as specified. Fix the problem as explained below and then try printing again.
Notice Page regarding memory full on IMC board
●
When the Staple function is not selected:
Disable the ROPM function by removing the checkmark from
"ROPM" in the "Configuration" tab of the printer driver setup
screen. (See "CONFIGURING THE PRINTER DRIVER" in the
software setup guide for network printer.) If you need to use the
ROPM function, lower the resolution setting in the printer driver
or install more memory.
●
When the Staple function is selected:
Lower the resolution setting or increase the "MEMORY FOR
PRINTER" setting in the key operator programs. If this does not
resolve the problem, install more memory.
When data loss error has occurred:
• Set the page protection function or enable the ROPM function.
To enable the ROPM function, select the "ROPM" checkbox in
the "Configuration" tab of the printer driver setup screen. (See
"CONFIGURING THE PRINTER DRIVER" in the software
setup guide for network printer.)
☞
PAGE PROTECTION
****************************************************
Notice Page
****************************************************
The IMC memory full error had occurred,
a normal output was not able to be executed.
Please refer to the operation manual for
the solution method.
The IMC memory is used to store print data when the
ROPM function is used. This memory is also used to
store original image data in the copy mode. The
percentage of IMC memory allocated to the printer
function can be adjusted using a key operator program.
See "MEMORY FOR PRINTER" in the key operator's
guide. The memory can be extended by adding
commercially available memory modules. For details,
contact your SHARP dealer.
****************************************************
Notice Page
****************************************************
The data loss error had occurred, a normal
output was not able to be executed.
Please refer to the operation manual for
the solution method.
Note