Sharp DT-400 Projector User Manual


 
-15
Quick Start
Page 29
4. Select the INPUT mode
6. Adjust the projector angle, focus and zoom
Select the “INPUT 3” using the INPUT button on the projector or the INPUT 3 button on the remote control.
When pressing on the projector, input mode switches in order of :
INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 DIGITAL
When using the remote control, press / / / / / to switch the INPUT mode.
On the remote
control
On the
projector
""
""
" On-screen Display
5. Turn the video equipment on and playback
Pages 30, 31
3 Adjust the projector angle
using the HEIGHT ADJUST
button.
HEIGHT ADJUST
button
1
Adjust the focus
On the remote control
On the projector
1 Press .
2 Adjust the focus by pressing \ or |.
2
Adjust the projected image size by adjusting zoom.
On the remote control
On the projector
1 Press .
2 Adjust the zoom by pressing ' or ".
1 Press .
2 Adjust the zoom by pressing ' or ".
1 Press .
2 Adjust the focus by pressing \ or |.
8. Turn the Power off
Press the STANDBY button, then press that button again while the confirmation message is displayed, to put
the projector into standby mode.
Unplug the power cord from the AC outlet after the cooling fan stops.
Page 28
On the remote controlOn the projector
""
""
" On-screen Display
7. Correct trapezoidal distortion
Horizontal Vertical
Select “H Keystone”
or “V Keystone”.
Correcting trapezoidal distortion using the Keystone Correction
Pages 32, 33
Adjust
On the remote control
DT400_E_P06_15.p65 04.10.18, 1:14 PM15