Filter
Top Products
STOP
FUNCTION
4
Setting 6: TEL/FAX REMOTE NUMBER (TRANSFER CODE)
If you hear a fax tone when you answer a call on a tone dial extension phone
connected to the same line as the fax, you can make the fax begin reception by
pressing 5, , and on the phone. Use this setting if you want to use a
number other than 5 to begin fax reception. You can enter any number from 0
to 9.
• Initial setting: 5
Press
until
display
shows:
TEL/FAX REMOTE #
Enter a number
from
0 to 9
REMOTE RECEPTION
Setting 7: REMOTE RECEPTION SELECT
If you don’t intend to use the above TEL/FAX REMOTE NUMBER, you can
turn detection of the number off. This will ensure that the fax never mistakenly
attempts to begin reception if it detects a signal similar to the TEL/FAX
REMOTE NUMBER while you are talking on an extension phone. Press 1 to
turn detection on, or 2 to turn detection off.
• Initial setting: 1
FUNCTION
4
Press
until
display
shows:
REMOTE RECEPTION
STOP
2
YES
NO
or
TRANSACTION LIST
1
Setting 8: TRANSACTION REPORT PRINT SELECT
This sets the condition for printing out a Transaction Report. Enter a number
from 1 to 5 as follows:
1 (ALWAYS PRINT): A report will be printed after each transmission,
reception, or error.
2 (ERR/TIMER/MEM): A report will be printed after an error, timer
operation, or memory operation.
3 (SEND ONLY): A report will be printed only after a transmission.
4 (NEVER PRINT): A report will never be printed.
5 (ERROR ONLY): A report will be printed only after an error occurs.
• Initial setting: 3
STOP
FUNCTION
4
Press
until
display
shows:
TRANSACTION LIST
Enter a number
from
1 to 5
DIAL MODE
Option Settings
116