Filter
Top Products
Page 28 of 66
intelligent wireless platform
airClient™ Nexus User Guide
1. From the ’Summary Information’ page, click on the ’Ethernet Configuration’ link to change
Ethernet parameters.
2. Enter the ‘IP address’ and ‘IP mask’.
3. Click on ‘Apply Changes’ to effect the changes.
Figure 2-14 airClient Router Ethernet Configuration
2.8.2. Wireless Configuration
The wireless parameters need to be configured to allow the airClient Router unit to associate with an
airPoint™ or any third party access point.
Follow these steps below to configure the airClient Router/NAT Mode Wireless IP Settings parameters:
1. Click on the ‘Wireless Configuration’ link from the ‘Summary Information’ page.
2. Enter the wireless ‘IP address’, ‘IP Mask’, ‘Gateway IP’ address for the airClient unit.
3. Check the ‘Enable DHCP’ checkbox if the IP address can be obtained automatically from the
wireless link.
4. Click on the ‘Apply Changes’ to change the settings.