Filter
Top Products
Q
UALITY
OF
S
ERVICE
C
OMMANDS
4-289
policy-map
This command creates a policy map that can be attached to multiple
interfaces, and enters Policy Map configuration mode. Use the no form to
delete a policy map and return to Global configuration mode.
Syntax
[no] policy-map policy-map-name
policy-map-name - Name of the policy map. (Range: 1-32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
•Use the policy-map command to specify the name of the policy map,
and then use the class command to configure policies for traffic that
matches criteria defined in a class map.
• A policy map can contain multiple class statements that can be applied
to the same interface with the service-policy command (page 4-293).
• You must create a Class Map (page 4-289) before assigning it to a Policy
Map.
Example
This example creates a policy called “rd_policy,” uses the class command to
specify the previously defined “rd_class,” uses the set command to classify
the service that incoming packets will receive, and then uses the police
command to limit the average bandwidth to 100,000 Kbps, the burst rate to
1522 bytes, and configure the response to drop any violating packets.
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 100000 1522 exceed-action drop
Console(config-pmap-c)#