Filter
Top Products
P
ORT
C
ONFIGURATION
3-123
can force the settings for speed and mode.The following capabilities are
supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1 Gbps full-duplex operation
- 10Gfull - Supports 10 Gbps full-duplex operation
(Default: Autonegotiation enabled; Advertised capabilities for
RJ-45: 1000BASE-T – 10half, 10full, 100half, 100full, 1000full;
SFP: 1000BASE-SX/LX/LH – 1000full;
10G Modules: 10GBASE-LR – 10Gfull)
• Media Type – Shows the forced/preferred port type to use for the
combination ports.
(SMC8724ML3:
Ports
21-24;
SMC8748ML3: Ports 45-48)
- Copper-Forced - Always uses the built-in RJ-45 port.
-
SFP-Forced
- Always uses the SFP port (even if module is not
installed).
-
SFP-Preferred-Auto
- Uses SFP port if both combination types are
functioning and the SFP port has a valid link.
• Trunk – Indicates if a port is a member of a trunk. To create trunks and
select port members, see “Creating Trunk Groups” on page 3-125.
Note: Auto-negotiation must be disabled before you can configure or
force the interface to use the Speed/Duplex Mode.