Filter
Top Products
L
INE
C
OMMANDS
4-23
Command Usage
Communication protocols provided by devices such as terminals and
modems often require a specific parity bit setting.
Example
To specify no parity, enter this command:
speed
This command sets the terminal line’s baud rate. This command sets both
the transmit (to terminal) and receive (from terminal) speeds. Use the no
form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)
Default Setting
auto
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might
not be supported. The system indicates if the speed you selected is not
supported. If you select the “auto” option, the switch will automatically
detect the baud rate configured on the attached terminal, and adjust the
speed accordingly.
Console(config-line)#parity none
Console(config-line)#