SMC Networks SMC8748L2 Switch User Manual


 
C
ONFIGURING
THE
S
WITCH
3-98
Web – Click Port, Port Broadcast Control. Set the threshold any port, click
Apply.
Figure 3-46. Enabling Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following
disables broadcast storm control for port 1, and then sets broadcast
suppression at 500 packets per second for port 2.
Console(config)#interface ethernet 1/1 4-132
Console(config-if)#no switchport broadcast 4-138
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 500 4-138
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2 4-143
Information of Eth 1/2
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,1000M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#