Filter
Top Products
P
ORT
C
ONFIGURATION
3-101
Command Usage
• Input rate limit can be enabled or disabled for individual interfaces.
Command Attribute
•Port/Trunk – Display the port number.
• Rate Limit Status– Enables or disables the rate limit (Default: Enabled)
• Rate Limit Level - Sets the rate limit level.
Web - Click Port, Rate Limit, Input Port/Trunk Configuration. Enable the
Rate Limit Status for the required interfaces, set the Rate Limit Level, and
click Apply.
Figure 3-48. Configuring Input Port Rate Limiting
CLI - This example sets the rate limit for input traffic passing through
port 3.
Showing Port Statistics
You can display standard statistics on network traffic from the Interfaces
Group and Ethernet-like MIBs, as well as a detailed breakdown of traffic
based on the RMON MIB. Interfaces and Ethernet-like statistics display
errors on the traffic passing through each port. This information can be
Console(config)#interface ethernet 1/3 4-132
Console(config-if)#rate-limit input 25 4-147
Console(config-if)#