Sony DKA-MC2F Computer Hardware User Manual

1996 Sony Corporation Printed in Japan
Operating Instructions
Mode d’emploi
For the customers in the USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that any change or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
For customers in Canada
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
This card is a memory card of the type II, PCMCIA ATA
Do not to touch the terminals or allow them to come in
contact with metal surfaces.
Do not bend, drop or apply shock to the card.
Do not expose the card to heat, water or direct sunlight.
Sony takes no responsibility for loss of data recorded on
the card, should a malfunction lead to data erasure.
We recommend you to copy information written in the
memo column on the back of the card, as often repairs
require the complete replacement of the card.
Type PCMCIA ATA standard, type II
Memory capacity
DKA-MC2F: 2 megabytes
DKA-MC10F: 10 megabytes
Operating temperature
0°C to 40°C (32°F to 104°F)
Dimensions 85.6 × 54 × 5 mm (3
/8 × 2
/4 ×
/32 inches)
(l × w × h)
Mass About 43 g (1.5 oz)
Accessories Operating Instructions (1)
Design and specifications subject to change without notice.