Filter
Top Products
MAKING COPIES
25
3
Check RSPF open function
When enabled in program number 24 (p.65), this function may help prevent wasteful use of
toner that occurs when the RSPF cover is not completely closed.
If the start ( ) key is pressed when the RSPF cover is not completely closed, "CHECK
ORIGINAL" will appear in the display and copying may not take place. If copying does not
take place, copying can be performed by pressing the start ( ) key again, however, the
scan size set in "CHANGING A TRAY'S PAPER SIZE SETTING" (p.23) or "VALID COPY
WIDTH" (program number 25) (p.65) will be used.
If the RSPF cover is completely closed after "CHECK ORIGINAL" appears, copying will take
place at the normal size.
Using the RSPF
1
Make sure that an original has not been left on the document
glass.
2
Adjust the original guides to the size of
the originals.
3
Place the original(s) face up in the
document feeder tray without trying to
force them in.
The RSPF indicator on the operation panel will light
up. If this indicator does not light up, the originals are
not properly set or the RSPF is not properly closed.
4
Select the number of copies and any other copy settings, and then
press the [START] key ( ).
When this function is off, if the [Start] key ( ) is pressed to make a copy
with the RSPF cover open, parts outside of the original will be copied black.
Even when this function is on, if the [Start] key ( ) is pressed twice to
make a copy with the RSPF cover open, parts outside the original may be
copied black. To prevent excessive use of toner, make sure that the RSPF
cover is closed when making a copy.
• Originals that are 5-1/2" x 8-1/2" to 8-1/2" x 14" and 15 lbs. to 24 lbs. (56
g
/
m
2
to 90
g
/m
2
) can be used. A maximum of 50 pages can be placed at once.
• Straighten curled originals before placing them in the document feeder
tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to remove
any staples or paper clips from them.
• When a copy is made, the edges will not be copied (
image loss).
For the image loss, see the "SPECIFICATIONS" (p.91).
• When using the margin shift function, check the position of the margins
carefully. (p.38)
• The default output mode for copying from the RSPF is sort mode (P.33),
and a checkmark " " will automatically appear in the display (P.11). If
"SORT AUTO SELECT" is disabled in the user programs, the default
output mode will be non-sort mode. (P.65)
• To stop copying in the middle of a run, press the [CLEAR] key ( ).
• For the copy settings, see pages 27 through 39.
Note
Note
Original face up
Note
!FO-2080.book 25 ページ ２００９年５月１５日 金曜日 午前１０時４２分