Filter
Top Products
SD INTERFACE BOARD
HFBK-SD1
Sony Corporation 2005
Printed in Japan 2008.11.13
3-869-802-06(1)
•
•
For installation instructions, refer to “Mounting an Optional Board”
in the Operation Manual supplied with the product in which this
board is to be mounted.
OPERATION MANUAL
[Japanese/English]
•
•
•
NTSC 59.94i PAL 50i
1
MONITOR D-sub 9
2
DIP
1 Sync/Setup
•
•
•
2 Sync on G
3 RGB/YPbPr
4 /S
5 16:9/4:3
6 Crop/Squeeze
7 Delay
8 89H/90H
3
VIDEO BNC
4
SDI BNC
For the customers in the U.S.A.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
All interface cables used to connect peripherals must be shielded in
order to comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
This device complies with part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
For customers in Canada
This Class A digital apparatus complies with Canadian ICES-003.
For the customers in Europe
This product with the CE marking complies with the EMC Directive
issued by the Commission of the European Community.
Compliance with this directive implies conformity to the following
European standards:
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following Electromagnetic
Environment(s):
E1 (residential), E2 (commercial and light industrial),
E3 (urban outdoors) and E4 (controlled EMC environment, ex. TV
studio).
The manufacturer of this product is Sony Corporation, 1-7-1 Konan,
Minato-ku, Tokyo, Japan.
The Authorized Representative for EMC and product safety is Sony
Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart,
Germany.
1
2
HFBK-SD1
MONITOR VIDEO SDI
4
3