Sony KP-41S5B Projector User Manual


 
– 22 –
KP-41S5/41S5B/41S5G/
41S5K/41S5R/41S5U
RM-862
5-1. ELECTRICAL ADJUSTMENTS
HOW TO ENTER INTO SERVICE MODE
1. Turn on the main power switch of the set and enter into
standby mode.
2. Press the following sequcnce of buttons on the Remote
Commander.
Service adjustment to this model can performed with the sup-
plied remote commander RM-862.
“TT—” will appear in the top right comer of the screen.
Other status information wull also be displayed.
3. Press MENU on the commander to obtain the following
menu on the screen.
5
(ON SCREEN
DISPLAY)
(DIGIT 5) (VOLUME +) (TV)
PICTURE ADJUSTMENT
AFC mode 2
REF position 2
SCP BGR 1
SCP BGF 1
Trap Fo 0
Sub contrast Adj
Sub colour Adj
Sub brightness Adj
Green drive Adj
Blue drive Adj
Green cutoff Adj
Blue cutoff Adj
Gamma 0
Pre / overshoot 0
Y delay 3
GEOMETRY ADJUSTMENT in 4 : 3 mode
UP Corn Pin Adj
V Size Adj
V Position Adj
S Correction Adj
V Linearity Adj
H Size Adj
H Position Adj
Pin Amp Adj
Pin Phase Adj
AFC Bow Adj
AFC Angle Adj
EHT V Adj
EHT H Adj
Corner Pin Adj
LO Corn Pin Adj
WIDE
V Aspect 47
V Scroll 31
Upper V Lin 0
Lower V Lin 0
Left Blanking 1
Right Blanking 11
TEST MENU
> picture adjustment
Geometry
Wide
MSP
IC status
Current TV status
Convergence
123
45
8
6
7
10
9
Standby
TV POWER ON
VOLUME
+
MENU
RM-862
+
4. Move to the correspondind adjustment using the button
on the commander.
5. Move the button to the right
to enter the selected
adjustment.
6. Before TURN OFF is neccessary:
[DATAWRITE], [DATACOPY] in 4 : 3 and 16 : 9 mode.
7. Turn off the power to quit the service mode when adjust-
ments are completed.
SECTION 5
CIRCUIT ADJUSTMENTS
*
*
: Adjust only if AE board change.
For change CRT R-G-B is better CONVERGENCE
don't change in 16 : 9 mode.