Filter
Top Products
GB
36 The SET SETTING Menu
• Press the APA key when the full image is displayed on the screen. If the projected image includes
much black portion around it, the APA function will not work properly and some parts of the
image may not be displayed on the screen.
• You can cancel the adjustment by pressing the APA key again while “Adjusting” appears on the
screen.
• The picture may not be adjusted properly depending on the kinds of input signals.
• Adjust the items “Dot Phase,” “H Size” and “Shift” in the INPUT SETTING menu when you
adjust the picture manually.
Power Saving When set to “On,” the projector goes into power
saving mode if no signal is input for 10 minutes.
Although the lamp goes out, the cooling fan keeps
running. The power saving mode is canceled when a
signal is input or any key is pressed. In power saving
mode, any key does not function for the first 45
seconds after the lamp goes out.
Off
IR Receiver Selects the remote control detectors (IR receiver) on
the front and rear of the projector.
• Front&Rear: Activates both the front and rear
detectors.
• Front: Activates the front detector only.
• Rear: Activates the rear detector only.
Front & Rear
Illumination Selects whether the SONY logo on the top panel of
the projector lights when the projector is on.
Normally, this setting is “On.”
On
Panel Key Lock Locks all the control panel keys on the rear and side
panels of the projector so that the projector can be
operated only with the Remote Commander.
To lock the control panel keys, set to “On.”
When it is set to “On,” keeping the I/
1 key on the
control panel pressed for 10 seconds turns the
projector on when it is in standby mode, and turns the
projector to standby mode when the power is on. If
you keep pressing the MENU key for about 10
seconds when the power is on, the lock will be
released and “Panel Key Lock” is automatically set to
“Off.”
Off
Notes
Seittng items Functions Initial setting value