Filter
Top Products
29
GB
INSTALLATION Window
Chapter 4 Adjustments and Settings Using the SRX Controller
INSTALLATION
Selects how to install the projector.
Front: Selects front projection.
Rear: Selects rear projection.
LAMP SELECT
Selects whether to use one of two lamps or both lamps.
Dual: Select if you want to use two lamps.
Single: Select if you want to use only one of two lamps. In
this setting, you can further select the lamp to be used
automatically or manually.
Auto Lamp Select Mode
When you click the Full Auto Select radio button, the
lamp with fewer used hours is automatically turned
on. When you use the projector for a long period of
time, click the User-Defined radio button. If you
specify the hour between 4 and 24 hours by clicking
the / buttons, the two lamps turn on
alternately at the interval of the specified hours.
Manual Lamp Select Mode
You can specify the lamp to be used by clicking the
Lamp A or Lamp B radio button.
If you switch “LAMP SELECT” from “Single” to “Dual”
or when either Lamp A or Lamp B switches to turn on in
Auto Lamp Select Mode, the projected image will be cut
off momentarily.
TEST PATTERN
Displays a built-in test pattern on the screen for adjusting
the picture with no signal input from external equipment.
Click the radio button of the desired test pattern from
among “Cross Hatch,” “Cross Hatch (Invert),” “100%
White,” “100% Red,” “100% Green,” “100% Blue,”
“Checker Flag” and “Checker Flag (Invert).” When you do
not display a built-in test pattern, click the Off radio
button.
While a built-in test pattern is displayed on the screen, you
cannot change the screen mode and input select mode, and
cannot adjust the “PICTURE CONTROL” and “COLOR
FRAME.”
Note
Note