Filter
Top Products
User’s Guide
SET NW WPAGROUP
Enable or disable WPA group key mode. If enabled, this allows group keys to be used for data link encryption.
SET NW WPAGROUP [ENABLE | DISABLE]
(default = disabled)
SH NW WPAGROUP
Shows the state of the allow WPA group keys flag
sample output:
WPA-GROUP Disabled
SET NW WPAPSK
Sets the WPA PSK pass phrase or hex key. This value is only used if the authentication mode is WPA-PSK. The
argument to this command is either a pass phrase of 8-63 characters, or exactly 64 hex characters representing the
256 bit PSK value.
SET NW WPAPSK <key>
(default = “silex Group”)
SET NW WPATRACE
Sets the WPA trace level. note: this command is for diagnostic purposes only, and should not normally be used as
the trace can affect performance. A value of 0 disables the trace.
SET NW WPATRACE nn
(default = 0)
SET NW IROAM
International Roaming (802.11d)
Document #40181-420 Rev. B 50