Filter
Top Products
VAIO Digital Studio System Reference Manual
36
9 Align the module over the appropriate socket, noting the location of
pin 1 on the module and pin 1 on the socket.
10 Carefully but firmly insert the edge of the module into the socket.
11 Press down firmly and evenly at both corners until the module is
fully seated.
12 Replace the AGP card and secure using the screw removed earlier.
13 Replace the power supply (see “Replacing the Power Supply” on
page 45).
14 Replace the side cover (see “Replacing the Side Cover” on page 25).
15 Reconnect the power cord and turn on the computer.
Your computer automatically recognizes the extra memory and
configures itself accordingly when you turn on the computer. No further
action is required.
✍ When the module is fully seated, the handles on each side are straight up and
locked into the slot on each side of the module. If the handles are not totally
straight upright, continue to press down on each side of the module until the
handles lock into place.
✍ Be sure to press down firmly until the handle on the AGP slot is straight up and
locked into the slot on the AGP card.
Latch
Edge Connector