Filter
Top Products
BIOS Setup Utility
SY-K7VTA PRO
49
What you need to do is to disable 'COM2' (or UART2 or serial port 2) in
the bios under integrated peripheral setup.
I have installed my modem drivers several times and I still cannot get
my modem to work. Why?
If you are sure that the modem driver has been installed correctly, then you
need to install the south bridge driver from the SOYO CD, this is because
Windows does not properly recognize relatively new chipsets.
Audio Issues
I do not get any sound from my sound card. What could be wrong?
Please make sure the speaker is connected to the speaker out port on your
sound card.
In Device Manager, I keep getting yellow exclamation signs on my
sound port even though I have installed my sound driver several times
and I could not get my sound card to work. What is wrong?
It is likely that you did not have the correct driver installed. If you are sure
that the correct sound driver has been installed, then please install the
'south bridge' driver for the motherboard.
The sound is working in my system, but when I play CD music from
the CD-ROM, I do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the sound
card is not connected or it is loose.
The sound from my sound card is distorted when Windows starts.
What is wrong?
First, if you are using an ISA sound card, please make sure the IRQ
needed for the sound card is set to 'Legacy ISA' in the bios. In other words,
if your ISA sound card takes IRQ5, then set IRQ5 to 'Legacy ISA'. Next,
install the 'south bridge' driver for the motherboard.
The sound and everything else works fine except that the recorder and
microphone do not work. What is wrong?