Filter
Top Products
Hardware Installation
SY-P4I845PE
15
Step 5 Connect cables, case wire, and power supply
A. IDE Device Installation (HDD, CD-ROM)
This Motherboard offers two primary and one secondary IDE device
connectors (IDE1, IDE2), can support up to four high-speed Ultra DMA
33/66/100HDD or CD-ROM. IDE3 can support up to two high speed Ultra
DMA 33/66/100/133 HDD.
Connect the blue end of the ATA66/100 flat cable to the IDE device (HDD
or CD-ROM) and plug the other end to the primary (IDE1, IDE3) or
secondary (IDE2) directionally keyed IDE connector on the Motherboard.
You can also plug the serial ATA cable into the serial ATA connector or the
mainboard instead of using the IDE3 master connector. The ATA66/100
cable is backward compatible with ATA33 HDDs.
This Motherboard can support up to 6 HDDs.
There are four HDD connectors (IDE1, IDE2, IDE3, Serial ATA) on
motherboard. IDE3 is provided for IDE RAID or standard IDE function.
Note that when Serial ATA is used no hard disk can be connected as IDE3
master.
Pin1
IDE2
Secondary
IDE
IDE1
Primary
IDE
IDE 3