Filter
Top Products
Check Possible remedy
Are you trying to feed paper Youcan only feed paper in this way when the printer is
using the front panel buttons off-line. Set the printer off-line and then feed paper.
while the ON
LINEindicator
isilluminated?
Is the paper too thick? There prelimits to the thickness of paper that can be fed
in this way (one top copy and two NCR copies). Try
with thinner paper.
1
1
I
If the ASF is not operatingor is not feedingpaper correctly,check the
following:
Check
Possible remedy
Has the
ASFoptionbeen
Selectthisoption
selected with the DIP
switch?
Isthereleaseleversettothe
Thereleaselevershouldbe setto thesingle-sheet
~ ~sition?
position.
Is the ASF correctly
MakesurethattheASFisproperlyseatedontheprinter.
mounted?
Ispapercaught
up near the
Stop printing, remove thej
ammed sheet (you may have
print head?
to remove the ASF for this), and continue.
Are the left and right guides
If the left and right guides are too close together, the
too close together?
paper will not feed smoothly. Move them a little further
apart to allow the paper to feed freely.
Is there toomuch paper inthe
The ASF’Spaper feed hopper and stacker can hold 120
paper feedhopperorstacker?
sheets each. Make sure that there is no more paper than
this in either the hopper or stacker.
Was the paper fanned before
If this is not done, paper jams may occur. Remove the
king fed into the ASF?
stack of paper from the ASF and fan it before reinsert-
ing.
Has the paper been used al-
Only new, uncreased paper should be used with the
ready or is it creased?
ASF.
Are you trying to feed paper
You can onfy feed paper in this way when the printer is
using the front panel buttons
off-tine. Set the printer off-line and then feed paper.
while the ON
LINEindicator
is illuminated?
Is the paper too thick or too
There are limits to the thickness of paper that can be fed
thin?
in this way. Try with different paper.