Filter
Top Products
I
Powersupply
If the POWER indicatordoesnotilluminate,checkthe following:
Check
Is the power cable properly
plugged into the electrical
outtet?
Is power being supplied to
the outtet?
Is theprintervoltage correct?
Possible remedv
I
Turnoffthe@nter,ensure the power cable is securely
connected, and then turn the printer back on.
Turn off the printer, unplug it, and try with another
appliance to determine if electricity is being supplied to
that outlet.
Check thebottom panelof yourprinter toensurethat the
outletvoltagecorresponds tothevoltagerequiredby the
printer. If theydonot match, DONOT trytooperate the
minter. Contact vour surmlier.
Printing
If yourprinterdoesnotprint,or suddenlystopsprinting,checkthefollow-
ing:
Check
Possible remedy
Is the interface cable con- Check both ends of the cable - printer and computer to
nected securely?
make sure that the connector is firmly in position.
Is the ON
LINEindicator itlu-
IfitisnoCpress the~
ONLINE >buttontosettheprinter
minated?
on-line.
Is the
POWER indicator
If it is, the paper has run cut. Load more paper.
flashing?
Is the paper caught up inter-
Turn off the power, remove thej
ammedpaper, replace,
nally?
tumontheprinter, andcontinueprinting. Make sure that
the leading edge of the paper is smooth and uncreased.
Is the ribbon caught up
Turn off the power, remove the ribbon, retensionit, and
around the print head?
replace it. This problem occurs most frequently with a
worn ribbow so you may need to replace the ribbon.
Is the software you are using
Check the installation settings in your software, andre-
properly installed for your
install if necessary.
printer?
Can the printer perform self-
Tum the printer off, and turn it on again, holding down
test operations?
one of tie buttons to perform a self-test. If these do not
work, contact your dealer.
90