Sun Microsystems X4100 Server User Manual


 
Chapter 4 Maintaining the Sun Fire X4200 Server 4-21
6. Install the DVD-slot faceplate to the front bezel. See FIGURE 4-16:
a. Lay the bezel face-down on a work surface.
b. Use a No. 2 Phillips screwdriver to remove the two screws that secure the blank
filler panel to the bezel. Save the screws in a safe place because you will
reinstall them in a following step.
c. Remove the blank filler panel and set it aside.
d. Set the new DVD-slot faceplate in place in the bezel opening.
Ensure that the ejector button on the faceplate is oriented toward the bottom of
the bezel.
e. Use a No. 2 Phillips screwdriver to install the two screws that secure the
faceplate to the bezel.
FIGURE 4-16 Installing the DVD-Slot Faceplate to the Front Bezel
7. Install the DVD-ROM drive into the chassis. See FIGURE 4-17:
a. Align the rear of the DVD-ROM drive with the opening in the chassis.
b. Push the DVD-ROM drive into the chassis until the spring latch on the chassis
closes over the front corner of the drive.