E-6 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
E.3.2 Adapter List Screen
When you start the Fusion-MPT SAS BIOS Configuration Utility, the Adapter List
appears, as shown in
FIGURE E-1. This screen displays a scrolling list of up to 256 LSI
Logic SAS host adapters in the system and information about each of them.
TABLE E-2 describes the fields in this screen.
Use the arrow keys to select an adapter, then press Enter to view and modify the
selected adapter’s properties (and to access the other screens). After you select an
adapter and press Enter, the adapter’s devices are scanned and the Adapter
Properties screen appears. See
FIGURE E-3.
To change the Adapter boot order, use the -, +, Insert, and Delete keys while on the
Boot Order field. Press Insert or Delete to add or remove an adapter to or from the
boot order. Press the - and + keys to modify an adapter’s position in the boot order.
If you make changes to the boot order, the Configuration Utility prompts you to save
the changes before you exit the screen.
From the Adapter List screen, you can also press Alt+N to access the Global
Properties screen. See
FIGURE E-2. On this screen you can change global scope
settings.
*******************************************************************************
* LSI Logic MPT Setup Utility v6.02.00.00 (2005.07.08) *
* Adapter List Global Properties *
* Adapter PCI PCI PCI PCI FW Revision Status Boot *
* Bus Dev Fnc Slot Order *
* SAS1064 02 03 00 00 1.04.00.00-IR Enabled 0 *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* *
* Esc = Exit Menu F1/Shift+1 = Help *
* Alt+N = Global Properties -/+ = Alter Boot Order Ins/Del = Alter Boot List *
*******************************************************************************
FIGURE E-1 Adapter List Screen