Filter
Top Products
186
Chapter 9 PGL Commands
Create Form Command (Normal)
This command is used to enter CREATE Form Mode. The command structure
for entering CREATE Mode is:
Table 23. Enter CREATE Mode Command
Field Function Option/Modifier Selections
CREATE
Indicates CREATE Mode. Enter the current Special Function Control
Character followed by CREATE.
;Name Enter the name of the form in this
field.
Form names are allowed a maximum of
eight characters. The follownig ASCII
characters may be used in form names:
• Upper and lower-case A - Z
(HEX 41 - 5A and 61 - 7A)
• Number 0 - 9 (HEX 30 - 39)
• Dollar sign $ (HEX 24)
• Percent Sign % (HEX 25)
• Dash - (HEX 2D)
• At sign @ (HEX 40)
• Braces { } (HEX 7B and 7D)
• Parens ( ) (HEX 28 and 29)
• Tilde ~ (HEX 7E)
• Single quotes ‘ ‘ (Hex 60 and 27)
• Exclamation point ! (HEX 21)
• Pound sign # (HEX 23)
• Amersand & (HEX 26)
;FL
Form Length
This parameter sets the Form
Length in three ways:
• Automatic form length
• Specific form length in dot
rows.
• Default form length in dot rows
(Also see LFORM 6 and LFORM 8
Commands)
Enter 0 to set the Form Length to end
automatically after the longest element.
Enter a value from 1 - 65,535 dot rows to
set the Form Length to a specified amount.
To compute the desired number of dot
rows multiply length in inches by 72. To set
form length to the default (792 dot rows)
do not enter a value in this field.