Filter
Top Products
Making Selections on the Hardware
Installation Screen
1.
To move forward through each field, use the → key (Right Arrow) or the ↓ key (Down
Arrow). To move backward through each field, use the ← key (Left Arrow) or the ↑ key
(Up Arrow).
To move to the first field in the next category, press the
PgDn
key (Page Down). To move
to the first field in the previous category, press the
PgUp
key (Page Up).
To move to the very first category, press the
Home
key. To move to the very last category,
press the
End
key.
2.
After moving to a field, press the
Spacebar
to cycle through the possible settings for the
field. Stop at the desired setting and move to the next field.
3.
Press the
Set Up
key when you have finished all entries. Then the system prompts you to
press the
Enter, Esc,
or
Set Up
key.
4.
Press the
Enter
key to save the new settings or press the
Esc
key to discard the new
settings and return to MS-DOS. The system will restart in either case.
The selections you make on the Hardware Installation screen are backed up by the battery. All selections are
maintained even when the power is turned off. If the battery is removed for more than approximately 5
minutes (when installing an internal option, for example), or if the battery is discharged, the selections may
be invalid. When using the computer for the first time after the battery was removed or after the computer has
not been used for a long period, reset the appropriate values in the Hardware Installation screen to their
default values by pressing the
Ctrl-Spacebar
keys.
Each field on the Hardware Installation Screen is described on the following pages.
Getting Started 4-21