Filter
Top Products
3 SETTING OF BASIC COPY MODES
110 Enlargement and Reduction Copying
8
Press the [START] button.
y If the finishing mode is “Non-sort / Non-staple”, the original will be scanned and copy-
ing will start. If not, proceed to steps 9 and 10.
9
Place the next original, and press the [START] button.
y Data scanning of this original starts.
y The next original will also be scanned in the same manner when you press the [YES]
button on the touch panel and then press the [START] button on the control panel.
y Repeat the above procedure until the scanning of the last page of the original fin-
ishes.
10
When scanning of all pages has finished, press the [FINISHED] but-
ton on the touch panel.
Copying starts.
When placing photo originals in other sizes
1
Press the [CUSTOM] button.
2
Key in the original size.
Key in the value of the width (X) of the original, and then press the [SET] button. Then
key in its length (Y). Acceptable ranges are as follows:
Width (X): 10 to 434 mm (0.39" to 17.09")
Length (Y): 10 to 300 mm (0.39" to 11.81")