Filter
Top Products
3.20 ONLY ONE TEST 3 Tests and Diagnostics
Slide the switch to OFF position. Then, the following message appears in the
display.
KILL SWITCH ON !!
Slide the switch to ON position. Then, the following message appears in the
display.
KILL SWITCH OFF !!
After Sliding the switch to OFF position, the screen returns to the ONLY
ONE TEST menu automatically.
Subtest 05 USB
NOTE: When executing this subtest, USB test module and USB cable must be
connected.
This subtest checks if USB ports work properly.
The following menu appears in the display.
#################################################################
######## ONLY ONE TEST Menu (XXXXXXXXX) #######
#################################################################
* *
* 0 ............ Port 0 *
* 1 ............ Port 1 *
* 2 ............ Port 2 *
* 3 ............ Port 3 *
* 9 ............ EXIT *
* *
*****************************************************************
.... Press test number[0-3, 9] ?
Connect the USB test module and USB cable to the computer.
Input the test port number and press Enter.
OK message appears in the display if the test ends without a fail.
NG message appears in the display if an error is found during the test.
Confirm the connection of cable, and then execute the test again.
Press 9 and Enter to return to ONLY ONE TESST menu.
3-44 QOSMIO F10 Maintenance Manual (960-498)