Filter
Top Products
4.5 Keyboard/Bluetooth 4 Replacement Procedures
Installing the keyboard
The following describes the procedure for installing the keyboard (See Figure 4-7 to 4-9).
1. Turn the keyboard upside down and place it on the palm rest as its face down.
Connect the keyboard flexible cable to the connector CN3230 on the system board.
NOTE: After connecting the keyboard flexible cable, put the cable into the slit of the
computer.
2. Install the keyboard support plate from the palm rest side edge and secure it with
the following screws.
• M2.5×2.8B FLAT BIND screw x2
3. Turn the keyboard face up and put it on the computer. Make sure that there is no
space between the keyboard and the computer.
4. Secure the keyboard with the following screws.
• M2.5×2.8B FLAT BIND screw x2
5. Slide to set the speaker cover assembly and secure it with the following screw.
• M2.5×4B FLAT BIND screw x1
6. Install the keyboard brace by pressing it.
4-20 QOSMIO F10 Maintenance Manual (960-498)