Filter
Top Products
4 Replacement Procedures 4.5 Keyboard/Bluetooth
4.5.2 Bluetooth
Removing the Bluetooth
The following describes the procedure for removing the bluetooth (See Figure 4-10).
1. Disconnect the bluetooth flat cable from the connector CN4400 on the system board.
2. Turn up the insulator to take out the bluetooth module from the guide of the display
assembly.
3. Disconnect the bluetooth antenna cable (black cable with marking) from the
bluetooth module.
4. Disconnect the bluetooth flat cable from the connector on the bluetooth module.
bluetooth flat cable
Guide
bluetooth antenna cable
Marking
bluetooth module
Insulator
CN4400
Figure 4-10 Removing the bluetooth module
Installing the Bluetooth
The following describes the procedure for installing the bluetooth (See Figure 4-10).
1. Connect the bluetooth flat cable to the connector on the bluetooth module.
2. Connect the bluetooth flat cable to the connector CN4400 on the system board.
3. Turn up the insulator to fit the bluetooth module to the guide of the display
assembly.
4. Connect the bluetooth antenna cable (black cable with marking) to the bluetooth
module.
QOSMIO F10 Maintenance Manual (960-498) 4-21