Toshiba 960-498 Personal Computer User Manual


 
4 Replacement Procedures 4.9 SD board/MDC
M2.5x4B FLAT BIND
SVP harness
CN2410
SD board flat cable
RJ11 connecto
r
Speaker cable L
TV tuner cable
CN9614
TV tuner coaxial cable
M2.5x4B FLAT BIND
Core
CN9510
CN9615
USB harness
CN4620
PJ6002
PJ6003
Speaker cable R
Figure 4-19 Removing the SD board
Installing the SD board
The following describes the procedure for installing the SD board (See Figure 4-19).
1. Install the RJ11 connector and its core to each slot of the base assembly.
2. Install the SD board and secure it with the following screws. When installing, pass
the USB harness through the cut area of the SD board.
M2.5×4B FLAT BIND screw x4
3. Connect the USB harness to the connector CN4620 on the SD board.
4. Connect the speaker cable L (red cable) and speaker cable R (blue cable) to the
connectors CN6002 and CN6003 on the SD board.
5. Connect the SD board flat cable, TV tuner coaxial cable, TV tuner cable and SVP
harness to the connectors CN9510, CN2410, CN9614 and CN9615 on the SD board
respectively.
QOSMIO F10 Maintenance Manual (960-498) 4-33