Filter
Top Products
4.14 TV tuner module/Guide 4 Replacement Procedures
Installing the TV tuner module
The following describes the procedure for installing the TV tuner module (See Figure 4-26).
1. Insert the TV tuner module terminals slantwise into the connector on the system
board and secure it with the following screws.
• M2×4Z BIND screw x2
2. Connect the TV tuner coaxial cable to the connector on the TV tuner module.
3. Connect the TV tuner harness to the connector on the TV tuner module.
4.14.2 Guide
Removing the guide
The following describes the procedure for removing the guide (See Figure 4-27).
1. Disconnect the TV tuner harness from the connector on the TV tuner module.
2. Disconnect the TV tuner coaxial cable from the connector on the TV tuner module.
3. Disconnect the USB harness from the connector CN4612 on the system board.
4. Pull out the USB harness, TV tuner harness and TV tuner coaxial cable from the
guide.
5. Remove the following screw and remove the guide.
• M2×4Z BIND screw x1
4-42 QOSMIO F10 Maintenance Manual (960-498)