Filter
Top Products
4 Replacement Procedures 4.20 Touch pad
4.20 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-36).
1. Remove the glass tape fixing the touch pad flexible cable.
2. Disconnect the touch pad flat cable from the touch pad.
3. Remove the following screws fixing the touch pad plate and remove the touch pad
plate.
• M2.5×2.8B FLAT BIND screw x4
4. Remove the following screws securing the touch pad.
• M2.5×2.8B FLAT BIND screw x2
5. Peel off touch pad to remove.
M2.5x2.8B FLAT BIND
Glass tape
M2.5x2.8B FLAT BIND
Touch pad flat cable
M2.5x2.8B FLAT BIND
M2.5x2.8B FLAT BIND
Touch pad
Figure 4-36 Removing the touch pad
QOSMIO F10 Maintenance Manual (960-498) 4-53