Filter
Top Products
2 Troubleshooting Procedures 2.4 System Board Troubleshooting
Table 2-6 Debug port (Resume mode) error status (2/4)
LED Status Test item Contents
(F122h) AC'97 control
Initializing of temperature control information
Initializing of KBC
VGA display-off and Reset control
Initialization of devices necessary for
initialization before initializing PCI bus 2
Starting recovery of VGA
Initializing of sound
Acquires the multi-box status.
Initializing of HC, recognizing of devices
Control of permission/prohibition for built-in LAN
Check of the checksum of conventional
memory
Resume error DPORT = F174H
Initializing of PCI devices
F123h
Check of WakeUp factors after initializing
PCI bus
Waiting for initializing of devices which
have to be initialized before setting HW
by PnP resource
Waiting for completion of MultiBox status check
(for models supporting Selectable bay)
Processing of RESUME for PnP
Tentative initialization of printer port (for models
supporting printer)
Serial interrupt control (for models supporting
YEBISU)
Waiting for the completion of VGA power-down
control (because the VGA configuration can not
be seen)
Processing of RESUME for PCI
Recovery of FDC (for models supporting built-in
FDD)
Checks slots that were in ON status during
suspending ( for models supporting fingerprint
authentication)
Recovery of PCMCIA card
Error when an ATA card is pulled out (for models
supporting ATA boot )
Resume error DPORT = F17Bh
Executing of dividing process of device detection
of PC card
Initializing COM (for models supporting SIO)
Recovery of each device (1)
Initializing FIR (for models supporting FIR)
Check of HDD pack connection
Resume error when HDD is mounted
DPORT=F172h
F124h
Start of IDE device resume sequence
QOSMIO F10 Maintenance Manual (960-498) 2-33