Toshiba 960-498 Personal Computer User Manual


 
2 Troubleshooting Procedures 2.11 Modem Troubleshooting
2.11 Modem Troubleshooting
To check if the modem is defective or malfunctioning, follow the troubleshooting procedures
below as instructed.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
Execute the Modem Test in the Diagnostic Program. Refer to Chapter 3, Tests and
Diagnostics for more information on how to perform the test program.
If any error is detected, perform Procedure 2.
Procedure 2 Connector Check and Replacement Check
An MDC (Modem Daughter Card) is used as the modem for this computer. The MDC is
connected to the SD board which is connected to the system board. If the modem
malfunctions, these connections or boards may be bad or the MDC might be faulty.
Disassemble the computer following the steps described in Chapter 4 and perform the
following checks:
Check 1 Make sure the following connections are firmly connected.
If any connector is disconnected, connect it firmly and return to Procedure 1. If
there is still an error, perform Check 2.
Check 2 The Modem jack (RJ11) may be faulty. Replace it with a new one. If the problem
still occurs, perform Check 3.
Check 3 The MDC may be faulty. Replace it with a new one following the steps in Chapter
4. If the problem still occurs, perform Check 4.
Check 4 The SD board may be faulty. Replace it with a new one following the instructions
in Chapter 4. If the problem still occurs, perform Check 5.
QOSMIO F10 Maintenance Manual (960-498) 2-51