Filter
Top Products
4 Replacement Procedures 4.25 Fluorescent lamp
4-56 PORTEGE A100 Maintenance Manual (960-460)
4.25.1 Replacing the 12.1 inch TDM fluorescent lamp
The following describes the procedure for replacing the fluorescent lamp. (See Figure 4-44 to
4-55.)
Disassembling the module
1. Peeing of tape and insulating sheet
<Procedure>
1) Put quietly the module on a flat plate without foreign objects with the front up.
Check for dusts on the desk to protect the module from being scratched. Put a
protection sheet (soft cloth) on the surface.
2) Peel off two tapes fixing FL cable and one bezel tape on the lamp side in order.
Caution: Be careful not to damage the TAB.
Tape fixing FL cable
Bezel tape on the lamp side
Figure 4-44 Replacing TDM fluorescent lamp(1)