Open as PDF
3 Tests and Diagnostics 3.29 Sound Test program
3-84 PORTEGE A200 Maintenance Manual (960-499)
220.127.116.11 Audio CD
Insert an audio CD and the following menu appears in the display.
CD/DVD TEST IN PROGRESS XXXXXXXX
xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] ; test end
[Ctrl]+[C] ; key stop
SUB-TEST : XX
PASS COUNT : XXXXX ERROR COUNT: XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
CD Sound track number (01-98 : Track) ?
Drive # = 0, ATAPI status =00
Command = XX
[[Block address = XXXXXXXX]]
[[Block length = XXXXXXXX]]
Final : Block address = XXXXXXXXX
Select the track number you want to test and press Enter twice.
The following message appears in the display and selected track is played.
Play start CD sound !
Press any key <play stop>
After pressing any key, the music stops and the display returns to the selection menu of the track
Note: When the CD-ROM test is executed, [ALL DEVICE] must be selected in the
“Device Config.=” of the BIOS SETUP. If the “ALL DEVICE” is not selected,
music can not be played.
3.29.4 CD Sound (Legacy) test
To execute the CD Sound (Legacy) test, select 4 and press Enter.