Open as PDF
4 Replacement Procedures 4.8 Palm rest/Touch pad
4-20 PORTEGE A200 Maintenance Manual (960-499)
Installing a palm rest
The following describes the procedure for installing a palm rest. (See Figure 4-11 and 4-12.)
1. Set the palm rest from the left side while guiding the two holes of the palm rest to the
Caution: When setting the palm rest, fit the position of wireless LAN switch on the
system board and the position of slider on the palm rest.
2. Fix the palm rest with the following screws.
? M2?3C S-THIN HEAD screw ?2
? M2.5?12B FLAT HEAD screw ?1
3. Connect the flat cable to the connector PJ 3240 on the system board.
4. Turn over the computer and fix the palm rest with the following screw.
? M2?3C S-THIN HEAD screw ?1