Open as PDF
4.10 Memory module 4 Replacement Procedures
PORTEGE A200 Maintenance Manual (960-499) 4-25
Installing a memory module
To install a memory module(s), confirm that the computer is in boot mode. Then perform the
following procedure. (See Figure 4-16.)
1. Turn up the insulator and insert the memory module into the connector of the
computer slantwise with the label up.
2. Push down the memory module until it is latched firmly
Caution: The power must be turned off when you insert the memory module. Inserting a
memory module with the power on risks damaging the module or the computer
Do not install a memory module in slot B only. Use slot A prior to slot B.
Otherwise, the computer or the memory may be damaged.
Never press hard or bend the memory module.