Open as PDF
4.16 RTC battery 4 Replacement Procedures
PORTEGE A200 Maintenance Manual (960-499) 4-35
4.16 RTC battery
Removing the RTC battery
To remove the RTC battery, perform the following procedure. (See Figure 4-25.)
1. Peel off the glass tape and disconnect the RTC battery cable from the connector
PJ8760 on the system board.
2. Remove the RTC battery and cushion.
Figure 4-25 Removing the RTC battery
Installing a RTC battery
To install a RTC battery, perform the following procedure. (See Figure 4-25.)
1. Connect the RTC battery cable to the connector PJ8760 on the system board.
2. Set the RTC battery and cushion into the slot and put the RTC battery cable into
the space between the fan and system board.
3. Stick the glass tape.
Caution: Be careful not to stick the glass tape on the GND pattern.
RTC battery cable