Open as PDF
4.26 Fluorescent lamp 4 Replacement Procedures
PORTEGE A200 Maintenance Manual (960-499) 4-61
4.26.1 Replacing the 12.1 inch TMD fluorescent lamp
The following describes the procedure for replacing the fluorescent lamp. (See Figure 4-50 to
Disassembling the module
1. Peeling of tape and insulating sheet
1) Put quietly the module on a flat plate without foreign objects with the front up.
Check for dusts on the desk to protect the module from being scratched. Put a
protection sheet (soft cloth) on the surface.
2) Peel off two tapes fixing FL cable and one bezel tape on the lamp side in order.
Caution: Be careful not to damage the TAB.
Figure 4-50 Replacing TMD fluorescent lamp(1)
Tape fixing F
Bezel tape on the lamp