Filter
Top Products
2. MAJOR UNIT REPLACEMENT
EO18-33018
2.7 Replacing the Platen
2-14
Print Head
Head Block
Release Lever
2.7 Replacing the Platen
1) Prior to replacing the platen, print out the maintenance counter for future reference.
2) Open the top cover, and raise the print head block by pressing down the head block release lever.
3) While pulling the top part of the platen holders L and R to the center of the printer, move them to the front
of the printer to remove.
4) Push the platen and strip plate to the left side and then, move them to the front side to remove.
5) Remove the shaft holder from the platen.
NOTE: Be careful not to damage the shaft holder when removing it.
1
2
Top Cover
Platen Holder L
Platen Holder R
Platen
Strip Plate
Shaft Holder
Shaft Holder
Platen