Filter
Top Products
4.4 HDD 4 Replacement Procedures
QOSMIO F30 Maintenance Manual (960-555) [CONFIDENTIAL] 4-15
Installing the HDD
The following describes the procedure for installing the HDD (See Figure 4-5 to 4-7).
1. Install the HDD to the HDD holder and secure it with the following screws.
• M3.0×4S S-THIN HEAD screw ×4
NOTE: Although they are 3mm head screws, screw torque must be set in 0.294 N·m
(3.0Kgf·cm) for four screws securing the HDD holder.
2. Insert the HDD-2 assembly into the HDD-2 slot and connect the connector carefully
to the connector on the system board.
3. Install the HDD-2 slot cover and secure it with the screw (with e-ring).
4. Insert the HDD-1 assembly into the HDD-1 slot and connect the connector carefully
to the connector on the system board.
5. Secure the HDD-1 assembly with the following screw.
• M2.5×6B FLAT BIND screw ×１
6. Install the HDD-1 slot cover and secure it with the screw (with e-ring).