Filter
Top Products
4.15 LCD Module 4 Replacement Procedures
Installing the LCD Module
NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Install the LCD module according to the following procedures and Figures 4-29, 4-30.
1. Turn the LCD upside down.
2. Connect the LCD/FL cable to the LCD module connector.
3. Turn the LCD right side up.
4. Place the LCD bracket in the correct position and secure it with three M2x3 black flat
head screws on each side.
5. Please the LCD module in the correct position and secure it with two M2.5x5 black
flat heat screws on each side.
CAUTION: When installing the LCD module, please follow below instruction:
When plug in LCD/FL cable into LCD module connector, need to plug horizontally. For
Sharp panel, if LCD/FL cable connector is not plugged horizontally, it may be damaged.
Satellite L300/L305/ Satellite Pro L300/ EQUIUM L300/ SATEGO L300 Maintenance Manual 4-51