Filter
Top Products
User’s Manual 3-18
Hardware, Utilities and Options
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes, if required).
5. Loosen the screws securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Removing the memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
holding it down until the latches on either side snap into place.
Seating the memory module
Use a point size 0 Phillips screwdriver.
1. Memory module cover 2. Screws
1. Notch 3. Slot A
2. Slot B
1
2
1
2
3