Filter
Top Products
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3-6 TECRA M1 Maintenance Manual (960-436)
5. The following message will appear:
ERROR STOP : YES/NO
Then, use the left or right arrow keys to move the cursor to the desired option and press
Enter.
Selecting YES stops the test program when an error is found and displays the operation
guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
These three selections have the following functions respectively:
1. Terminates the test program and exits to the subtest menu.
2. Continues the test.
3. Restarts the test from the error.
Selecting NO keeps the test running even if an error is found.
6. Use the arrow keys to move the cursor to the desired option and press Enter.
Table 3-1 in section 3.3 describes the function of each test on the subtest menu. Table 3-4
in section 3.21 describes the error codes and error status for each error.