Filter
Top Products
4 Replacement Procedures 4.9 MDC Module
4.9 MDC Module
Removing the MDC Module
Remove the MDC Module (Modem Daughter Card) according to the following procedures
and Figures 4-18, after checking that the computer is turned off in boot mode.
CAUTION: Remove the MDC module after turning off the computer. If this is violated,
the computer or MDC module can be damaged.
1. Remove the two M2x2 black flat head screws securing the MDC module.
2. Left the MDC module and disconnect it from CN15 on the system board.
3. Disconnect the MDC cable from connector JP1 on the MDC card.
CAUTION: Do not touch the connectors on the MDC module or in the computer.
Contaminated connectors can cause MDC module failures.
M2x2 black flat head screw
CN15
CN8
MDC card
MDC cable
JP1
Figure 4-18 Removing the MDC module
4-34 Satellite M200/M205 / Satellite Pro M200/ EQUIUM M200/ SATEGO M200 Maintenance Manual