Filter
Top Products
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3.2 Executing the Diagnostic Test
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive.
2. Insert the Diagnostics disk in the USB floppy disk drive and turn on the computer
while pressing U key. Then, press Enter and the following menu appears.
TOSHIBA Diagnostics Startup Menu
---------------------------------------------------------
(M) Main
(I) Initial config set
(H) Heatrun
Enter a choice: M
To start the Diagnostics menu (T&D), press M or m and Enter.
To start the H/W initial information setting tool, press I or i and Enter.
To start the Heatrun test, press H or h and Enter.
NOTE: After replacing the system board or CPU, it is necessary to execute the subtest 01
Initial configuration in 3.3 Setting of the hardware configuration.
3.2.1 Diagnostics menu (T&D)
To execute this program, press M or m in the startup menu, press Enter. The following
menu appears.
TOSHIBA personal computer XXXXXX DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 20XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 – ONLY ONE TEST
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
3-4 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)