Filter
Top Products
145
Exploring Your Computer’s Features
Using the Ultra SlimBay II
Removing a module from the Ultra SlimBay II
Use caution when lifting or turning your computer. Failure to do so
may result in damage to components, such as cables, attached to
your computer, or to the computer itself.
1 Do one of the following:
❖ Turn off the computer.
❖ Leave the computer on and hot swap the module. First,
stop the module by clicking the Safely Remove
Hardware icon on the System tray, then selecting the
module to be removed. If the system is unable to prepare
the module for safe removal, a message will tell you to try
again later. If the module can be removed now, the system
displays Safe to Remove Hardware. After the module is
stopped, it is safe to remove it.
Before you turn the computer over, make sure that the computer
display is properly closed and is not in tablet mode. Setting the
computer down on the display may cause damage to the screen.
2 Slide the Ultra SlimBay II release toward the back of the
computer.
(Sample Illustration)
Sliding the release latch
NOTE
Front of computer