Filter
Top Products
3M
™
Multimedia Projector MP8745 © 3M 1999
ENGLISH
12
3.1 Projector Startup
Section 3: Basic Operations
Figure 3.1 Projector Controls
1. Make all cable connections and line hookups with the power off.
2. Turn the POWER SWITCH of the projector on. The POWER indicator will light up orange.
3. Press the STANDBY/ON button . The POWER indicator blinks (green) and then lights (green).
The POWER indicator will blink green during warm-up and lamp ignition. When power is turned off,
there is a 60 second reset period before the STANDBY/ON button will function again.
4. Adjust the screen size by pressing the ZOOM button.
5. Adjust the focus by pressing the focus button.
Press any other button to make the focus screen disappear.
6. Turn on all connected equipment. Refer to section 2.3.
7. Press the INPUT button on the projector or the INPUT SELECT (VIDEO or RGB) button on the
remote to select the source of the signal to be projected on the screen. The selected signal input is
displayed at the bottom right of the screen. The display will show the last selected input source before
power was turned off.
3.2 Projector Shutdown
1. Press and hold the STANDBY/ON button for 1 second. The POWER indicator blinks orange and
the lamp turns off. After approximately 1 minute, the fan stops and the indicator stays orange.
2. Turn the MAIN POWER SWITCH of the projector off.
3. Attach lens cap to protect projection lens.
4. Disconnect cables if moving projector to new location.
Caution
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is
pressed, the fan rotates for about 1 minute to cool the projector.
+
–
ZOOM
+
–
FOCUS
OI
STANDBY ON
INPUT
OI
STANDBY ON
MP8745
+
ZOOM
MUTE
INPUT
STANDBY ON
RESET
PO
W
ER
LA
MPTEMP
MENU
+
FOCUS
MP8745
PORTABLE PROJECTOR
OI
+
ZOOM
MUTE INPUT
STANDBY ON
RESET
POWERLAMP TEMP
MENU
+
––
FOCUS
EPS-130A